How to Start a Car That’s Been in Storage

Not sure how to start a car that’s been in storage? Read on and find all the necessary info.

When a car has been sitting for a long time, it’s important that special precautions are taken before it’s started or driven again. This will ensure the car is able to function properly once it’s on and that there aren’t any internal problems that have to be fixed later on. It doesn’t matter whether you stored your vehicle by renting a storage unit (available storage units in Brisbane) or kept it in your garage for only special occasions, the preparation before turning it on is essential. By using the information below and you’ll keep your vehicle working just like you expect it to!

 

How Long Has Your Car Been Stored?

 

It doesn’t matter how long your car has been parked, you have to make sure you prepare it before you fire it up. If your car has only been out of commission for a few months because of the cold winter weather, then start by doing an oil change. Don’t forget to change out your filter as well, because this could have gotten dirty. In addition to this, you should drain the gas tank and flush the fuel lines. Instead of stopping there, continue by draining and flushing your radiator coolant. Replace all of these fluids once you’re done, and then move onto the steps below.

 

If your car has been stored for many years, then you are best off draining, bleeding, flushing and replacing all fluids in the car. This may seem like a lot of extra steps, but they are very important ones. Once you’re done with that, you can move onto the steps below.

 

Steps for Safely Starting Your Car:

 

1. Leak Check

 

Look on the ground underneath the vehicle to see if there are any stains. When you do this you’ll be looking for leakage that could have come from the brakes, coolant system, gaskets, radiator or anything else inside of the vehicle. If you don’t see anything, then move on to the next step.

 

2. Battery Check

 

If you removed your battery before storing the vehicle, then all you have to do is give it a charge and then put it back in the vehicle after cleaning it off. If it’s been a while, then the best option is to buy a new battery and cables for it. This is because cables become less conductive as they age, and that can mean they don’t work at all when you need them to.

 

3. Lubricate Cylinders

 

It’s important to take your spark plugs out and lubricate the cylinders that are under them. That will ensure that piston rings do not get stuck. With the spark plugs still off, turn the engine over a few times so that the cylinders can become lubricated. Then, replace the spark plugs and move to the next step.

 

4. Engine Starter Fluid

 

Before turning on the car, spray engine starter fluid into the carburetors by taking off your air filter covers (tutorial).

 

5. Turn the Car On

 

Turn the keys to the ignition and lightly pump the gas pedals a couple of times. After that, let the car idle for a few minutes so that it can warm up and get all the fluids moving around. Before you drive the vehicle off, get out and check for any leaks on the ground once again, and then you will be ready to go!

0 Shares:
Leave a Reply

Your email address will not be published. Required fields are marked *

You May Also Like